BIGGER PICTURE Energy & climate
Giving wastewater bacteria the air they actually need
Cuxhaven’s treatment plant used a virtual model to adjust aeration—even where a real-time sensor was missing.

- Reported reduction
- 30% of aeration electricity
- Controlled process
- Five parallel biological tanks
- Constraint
- Effluent limits still met, according to the supplier
How the idea works
Estimate incoming load
Virtual sensors infer nutrient and carbon concentrations.
Model oxygen demand
The treatment model estimates the air needed for elimination.
Adjust aerators
Controls match aeration to changing load and effluent targets.
Clean water has an electricity bill
Biological wastewater treatment relies on processes that need oxygen. Supplying it with blowers and aerators consumes substantial electricity, so over-aeration is expensive. At Cuxhaven, EWE wanted to reduce that demand while keeping treated water within required limits. The aim was not simply to turn the air down, but to match it to the work the treatment process had to do.
A sensor made from relationships in the data
The plant lacked online measurements for some incoming pollutant concentrations. Xylem therefore built virtual sensors: models estimating carbon, nitrogen and phosphorus loads from available plant data. Those estimates fed a digital model of the treatment processes. This is a useful twist on AI: it can infer a missing process variable rather than requiring every quantity to be directly measured.
Five tanks became a control experiment
After a period of manual operation, optimized control began in August 2017 for five parallel biological treatment tanks. The system calculated aerator settings appropriate to the changing load. Xylem’s case accounts report 30% less aeration energy while maintaining effluent compliance. The comparison concerned the treatment process, not every electricity consumer on the site.
Keep the denominator visible
The accounts come from the technology supplier, rather than a randomized independent trial. They also give different annual kilowatt-hour equivalents in different versions, so the consistent 30% aeration figure is the clearest headline. For another utility, incoming wastewater, equipment and discharge requirements would need their own model and validation before assuming similar savings.